E103 Short Stroke Linear Position Sensor
Intrinsically Safe sensors for Hazardous DUST atmospheres

 

Measurement range: Factory set to any length from 10mm to 50mm in increments of 1mm. For example, if your application requires 3/4" (19 mm) measurement then Positek will manufacture the sensor specifically for this length. The calibration will be set up for 19 mm.

Connector/Cable Options:	Option code
Connector IP67	J
Cable Gland IP67	L
Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.	Specified in cm after the L e.g. L200 for 200cm cable

Plunger Options:	Option code
Spring loaded (extended)	R
Dome end on plunger	T
Non captive plunger (not with Options 'R' or 'T')	V

 

Click Here For Approved Galvanic Isolation Amplifier Options

 

 

 

Free Design Service If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, Positek will be happy to modify or create a new design to suit your needs Contact Positek Technical Department - Click Here

 

Get Price