Measurement range: Factory set to any length from 10mm to 300mm in increments of 1mm. For example, if your application requires 10" (254 mm) measurement then Positek will manufacture the sensor specifically for this length. The mechanical length and calibration will be set up for 254 mm.

Connector/Cable Options:	Option code
Connector Axial IP67	J
Connector Radial, IP67	K
Cable Axial Gland IP67	L
Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.	Specified in cm after the L e.g. L200 for 200cm cable from axial cable gland

Mounting Options:	Option code
Rod eye on body (only with options I or K)	N
M5x0.8 male thread (body)	Blank
Rod eye on push rod	U
M5x0.8 male thread (push rod)	Blank

 

Push Rod Options:	Option code
Non captive push rod	V

 

Click Here For Approved Galvanic Isolation Amplifier Options

 

 

 

Free Design Service If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, Positek will be happy to modify or create a new design to suit your needs Contact Positek Technical Department - Click Here

 

Get Price