|
P111 Rugged Stand Alone Linear
Position Sensor.
Position feedback for industrial
and scientific applications
Available in any travel from 50mm
to 600mm.
Preferences
Positek offers a range of options for its standard sensors.
Each sensor is manufactured to suit the customer's individual
preferences.
If your requirement is outside the options given below,
Positek can modify/ redesign a sensor to suit your specific
requirement.
Standard options are available as below: |
Measurement range:
Factory set to any length from 50mm to 600mm in increments of
1mm.
For example, if your application requires 10" (254 mm)
measurement
then Positek will manufacture the sensor specifically for this
length.
The mechanical length and calibration will be set up for 254
mm. |
| Output Signal |
Supply Input |
Option code
|
| Standard |
|
|
| 0.5V-4.5V dc ratiometric |
+5V dc nom. ± 0.5V |
A
|
| Buffered |
|
|
| 0.5V-4.5V dc |
+24V dc nom. + 9-28V |
G
|
| ±5V dc |
±15V dc nom. ±
9-28V |
B
|
| 0.5-9.5V dc |
+24V dc nom. + 13-28V |
C
|
| ±10V dc |
±15V dc nom. ±
13.5-28V |
D
|
| 4-20mA (2 wire) |
+24V dc nom. + 18-28V |
E
|
| 4-20mA (3 wire sink) |
+24V dc nom. + 13-28V |
F
|
| 4-20mA (3 wire source) |
+24V dc nom. + 13-28V |
H
|
|
Connector/Cable Options:
|
Option code
|
| Connector - Hirschmann GD series
Axial, IP65 |
J
|
| Connector - Hirschmann Elwika
4102 Radial, IP67 |
K
|
| Cable with M12 gland
or short gland Axial, Gland IP67 |
L
|
| Cable with PG9 gland Radial,
Gland IP67 |
I
|
| Cable
length - The standard length of cable supplied with a Positek
position sensor is 50cm although you can specify any length
you require. |
Specified
in cm after the L ir I
e.g. L200 for 200cm cable from axial cable gland
|
| Mounting Options: |
Option code
|
| Body clamps (1 Pair) |
P
|
| Body clamps (2 Pairs) |
P2
|
| M8 Rod eye on push rod |
U
|
| Push Rod Options: |
Option code
|
| Spring loaded (extended) |
R
|
| Spring loaded (retracted) |
S
|
| Dome end on push rod |
T
|
| Non captive push rod |
V
|
Free
Design Service
If you need a position sensor that is
outside the scope of the above options to suit your installation
requirement or specification, Positek will be happy to modify
or create a new design to suit your needs
Contact
Positek Technical Department - Click Here
|
Back To Top
| Home Page | Quality | Products | Part
Number Coding | Case Studies |
| Help Desk | Enquiries | Distributors | How to find us |
|
