Available in any travel from 50mm to 600mm.

Overview Specification Preferences Drawings Certificates Datasheet

 

 

Measurement range: Factory set to any length from 20mm to 600mm in increments of 1mm. For example, if your application requires 10" (254 mm) measurement then Positek will manufacture the sensor specifically for this length. The mechanical length and calibration will be set up for 254 mm.

Galvanic Barrier Output Options:

Output Signal	Supply Input	Option code
0.5-9.5V dc	+24V dc nom. + 13-28V	Z010
4-20mA (3 wire source)	+24V dc nom. + 13-28V	Z420

Connector/Cable Options:	Option code
Connector - Hirschmann GD series Axial, IP65	J
Cable with M12 gland Axial, Gland IP67	L
Cable with short gland Axial, Gland IP67	M
Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.	Specified in cm after the L or M e.g. L200 for 200cm cable

The sensor can be supplied without access to the two trim pots (gain and offset) with the adjustment holes sealed.

Option code Y

 

Electronics Module:	Option code
Flanged	T
M18 Thread	P

 

Target Flange Options (see drawing TG24-11):	Option code
Penny and Giles HLP100	V
Temposonics (M4 fixing)	W
Parker Hannifin Cylinder Version	X

 

Approved Galvanic Barriers:	Order code
0.5 - 9.5 V dc Output version	BX002
4-20 mA Output version	BX003

 

 

 

Free Design Service If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, Positek will be happy to modify or create a new design to suit your needs Contact Positek Technical Department - Click Here

 

 

Get Price