Help Desk
Frequently Asked Questions
All Positek sensors with PIPS® technology are supplied complete with their own signal conditioning built into the sensor so they can poerate from a DC supply and provide a DC output. The output from the sensor is calibrated in the factory over the travel which is specified in the order. This makes them easy to install and connect up and you do not have to waste time setting them up and calibrating them.
Click here for basic fault test procedure
Calibration instructions for all Positek sensors
Connection Diagrams
For sensors, please select the relevant installation sheet (below).
Click here for Galvanically Isolated Amplifiers (for Intrinsically Safe sensors).
Installation Information
"P" Series Position Sensors
Non-hazardous applications
"S" Series Submersible Position Sensors
Hazardous and Non-Hazardous applications
"X" Series Position Sensors
Intrinsically safe for hazardous gas/vapour atmospheres
ATEX approved
ATEX approved
"E" Series Position Sensors
Intrinsically safe for hazardous dust atmospheres
ATEX approved
Intrinsically safe for hazardous dust atmospheres
ATEX approved
"M" Series Position Sensors
Intriniscally safe for hazardous mining atmospheres
ATEX approved
ATEX approved
"A" Series Position Sensors
Intrinsically safe for hazardous mining environments
ANZEx approved
ANZEx approved
"G" Series Position Sensors
Intrinsically safe for hazardous dust atmospheres
ATEX approved
Intrinsically safe for hazardous dust atmospheres
ATEX approved
"H" Series Position Sensors
Intriniscally safe for hazardous mining atmospheres
ATEX approved
ATEX approved