The Intrinsically Safe 10 bar X115 is a heavy-duty ATEX and IECEx approved version of the X114 sensor with a stronger 12.6mm push rod, recommended for applications where vibration is an issue or there is a need for longer travel sensors are to be mounted horizontally between rod eyes. Affordable, durable, high-accuracy position sensor Designed for applications where IP68 sealing is required up to a pressure of 10Bar. Highly compact and space-efficient, being responsive along almost its entire length Provides a linear output proportional to displacement Supplied with the output calibrated to the travel required, from 0-5mm to 0-800mm and with full EMC protection built in Very robust, the body and push rod being made of stainless steel for long service life and environmental resistance Overall performance, repeatability and stability are outstanding over a wide temperature range The sensor is easy to install with mounting options including stainless steel M8 rod eye bearings and body clamps The push rod can be supplied free or captive, with female M8 thread, or an M8 stainless steel rod eye Wide range of mechanical and electrical options, environmental sealing is to IP68 10Bar Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier . Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs. The sensor can be installed with a cable length up to 1km between the sensor and the amplifier. Click the buttons below for more downloadable information: Drawing, Datasheet, Installation Guide & P/N Configurator Body Clamps