The Intrinsically Safe E103 is ATEX and IECEx approved for use in potentially explosive gas/vapour and dust atmospheres. It is designed for a wide range of industrial applications and is ideal for OEMs seeking good sensor performance in situations where a short-bodied sensor is required for operation in hazardous areas. Compact and space-efficient, being responsive along almost its entire length Provides a linear output proportional to displacement Output calibrated to the travel required, from 0-2mm to 0-50mm and with full EMC protection built in Overall performance, repeatability and stability are outstanding over a wide temperature range The sensor has a rugged stainless steel body and plunger It is easy to install and set up, the stainless steel mounting flange has two 4.5mm by 30 degree wide slots on a 48mm pitch The plunger can be supplied free or captive, with female M4 thread, or spring-loaded with a ball end The E103 also offers a range of mechanical options, environmental sealing is to IP67 Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier . Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs. The sensor can be installed with a cable length up to 1km between the sensor and the amplifier. Click the buttons below for more helpful downloadable information: Drawing, Datasheet, Installation Guide & P/N Configurator Body Clamps