The intrinsically safe X502 rotary sensor is ATEX and IECEx approved for use in potentially explosive gas/vapour atmospheres. It is designed for industrial and scientific feedback applications, like the X500 but with better resolution at smaller angles of deflection, and is ideal for OEMs seeking good sensor performance for arduous applications in hazardous areas. Provides a linear output proportional with angle of rotation Supplied with the output calibrated to the angle required, between 5 and 15 degrees and with full EMC protection built in There is a machined registration mark to identify the calibrated mid point. Overall performance, repeatability and stability are outstanding over a wide temperature range Long service life and environmental resistance Rugged stainless steel body and shaft, the flange and servo mounts are anodised aluminium The flange or servo mounting options make the sensor easy to install Environmental sealing is to IP65 or IP67 depending on selected cable or connector options Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier. Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs. The sensor can be installed with a cable length up to 1km between the sensor and the amplifier. Click the buttons below for more downloadable information and guides: Drawing, Datasheet, Installation Guide & P/N Configurator